Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
CertainTeed Ridge Vent Installation: The Orlando Owner’s Guide
CertainTeed ridge vent installation in Orlando typically runs $450 to $900 installed for a standard 20 to 30 foot ridge line, depending on the specific CertainTeed vent profile your roof currently uses. We stock CertainTeed ridge vent rolls on our trucks, so in most cases we can complete the swap the same day we arrive. Homeowners usually discover a ridge vent has failed when they notice granule-colored debris in the gutters, water staining near the peak of a bedroom ceiling, or a sudden spike in the attic temperature during an Orlando August afternoon.
At Crestview Roofing Co Orlando, we install CertainTeed ridge vents as an independent roofing contractor. We’re not affiliated with CertainTeed directly, but we’ve installed their ventilation products across Central Florida long enough to know which profiles match which roof pitches and what fails first in this humidity. If your ridge vent is cracked, pulling away from the shingles, or letting rain blow in sideways during a summer squall, you’re in the right place to figure out exactly what you need and what it’ll cost.
Which CertainTeed Models This Applies To
CertainTeed makes two ridge vent lines that show up on Orlando roofs: the ShingleVent II and the Mountain Ridge. ShingleVent II is the most common on homes built after 2005. It’s a low-profile, shingle-over vent with an external baffle system, and it comes in 4-foot sections with the CertainTeed name printed on the underside. Mountain Ridge is the budget-friendly shingle-over option, also 4-foot sections but with a simpler internal baffle. Both use a 12-inch-wide roll that gets covered by cap shingles, but the nail line and end-cap details differ slightly between the two.
If you’re not sure which one is on your roof, check the attic side first. A ShingleVent II will show a black fabric filter that runs the full length of the peak. Mountain Ridge has visible molded plastic channels. If the vent has been there more than a decade, the printing on the underside of the plastic is usually faded beyond reading, so the attic check is more reliable than trying to match a label. Aftermarket ridge vents can work, but for CertainTeed shingle warranties that include the “SureStart Protection” period, mixing in a non-CertainTeed vent can give the manufacturer a reason to point fingers later. We always match OEM when the roof has a live manufacturer warranty, and we’ll tell you honestly if an aftermarket equivalent makes financial sense on a roof that’s out of warranty anyway.
Styles & brands we work with
Signs Your CertainTeed Ridge Vent Installation Is Failing
- Attic temperature keeps climbing. A working ridge vent pulls hot air out continuously. When the baffles clog with blown-in insulation or the vent was under-sized at install, the attic on a 92°F Orlando day can hit 140°F or hotter. That heat pushes down into your living space and makes your AC work harder than it should.
- Dark streaks or water stains near interior ceiling peaks. Not every ridge vent leak shows up as a drip. High-humidity air getting pulled in through a cracked vent often condenses on the underside of the roof deck first, leaving staining that looks like faint coffee drips around closet ceilings or hallway peaks before it ever becomes a visible leak.
- Cap shingles are lifting or curling off the ridge. The nails holding the cap shingles over the vent loosen as the plastic expands and contracts through Orlando’s heat-cool cycles. When you see shingles telegraphing the outline of the vent, the seal is compromised and water can ride straight down into the vent channel.
- You can see daylight through gaps at the ridge ends. Walk into the attic on a bright day with the lights off. If you see light coming through at either end of the ridge, the end caps or storm collars have shifted. That’s how Orlando’s side-blowing rain gets in, and water entering the ends travels the full ridge line before it shows up on a ceiling.
- Vent plastic is brittle or cracked when touched. CertainTeed ridge vent plastic has a real lifespan in Central Florida. UV exposure through the cap shingles, combined with 90% humidity days, makes the material brittle after 15 to 20 years. If a gentle press makes it crack, it’s time to replace the whole run, not patch one spot.
Replacement Cost & What’s Included
Most standard CertainTeed ridge vent replacement jobs in Orlando run $450 to $900 installed. That includes removing the old vent and cap shingles, verifying the roof deck opening is the right width, installing the new CertainTeed vent with proper nail spacing, and re-capping with new shingles that match or closely match your existing roof. A simple single-story roof with a 20-foot ridge lands at the lower end. A two-story home with a steep pitch, multiple ridge lines, or a ridge that runs 40 feet or more lands at the upper end.
Here’s the line-item breakdown so you know exactly where the money goes:
| Item | Typical Range (Orlando) |
|---|---|
| CertainTeed ShingleVent II (4-ft section) | $28 – $38 each |
| CertainTeed Mountain Ridge (4-ft section) | $20 – $28 each |
| Cap shingles (to match existing roof) | $40 – $120 per bundle |
| Nails, end caps, sealant | $25 – $50 |
| Labor (removal, install, cleanup) | $250 – $500 |
Every quote is itemized in writing before we start. The number on the page is the number on the invoice. And every ridge vent replacement is covered by our 365-Day Done Right Promise: if the installation fails within a full year for any reason related to how we installed it, we come back and fix it at no charge. Written guarantee, included with every job.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Here’s the honest split: if you’re trying to identify whether your CertainTeed vent is failing, there are things you can safely do from inside the attic. Look for the daylight at the ends, check for staining, measure the vent width so you know which model to buy. But installing a ridge vent means working at the peak of the roof, and in Orlando that means dealing with steep pitches, afternoon thundershowers arriving with no warning, and roof decks that get slicker than a boat ramp when wet. The most common DIY failure we see isn’t the vent itself. It’s the cap shingles being nailed in the wrong spot and splitting the vent channel, or the opening not being cut to the right width to match the vent’s airflow spec.
If you want to know exactly what you’re looking at, call us at (448) 218-0800. We’ll tell you over the phone what to check in the attic, and if it sounds like a real problem, Dylan Pace or one of our background-checked techs will come put a written quote in your hand before any work is scheduled.
FAQs
In Central Florida, expect 15 to 20 years out of a CertainTeed ShingleVent II, and 10 to 15 years out of a Mountain Ridge. The UV exposure and humidity here shorten the lifespan compared to other parts of the country by about 20%. If yours is at or past the 15-year mark, it’s worth having a professional eyeball it during your next roof check.
For small cracks at the very end of a vent run, a professionally applied patch can buy you a year or two. But once the plastic shows brittleness across more than one section, patching is throwing money at the problem. Replacement is the correct fix. Call us at (448) 218-0800 and we’ll give you an honest recommendation based on what we find.
A standard single-ridge replacement takes 2 to 3 hours for a crew that knows what they’re doing. We’ll have you a written timeline before we start, and we’ll tell you the exact crew member’s name before they arrive.
Yes, we stock both ShingleVent II and Mountain Ridge sections on our service trucks when we’re running ridge vent calls in Orlando. If we arrive for an estimate and you decide you want to go ahead, in most cases we have the parts on site and can complete the job right then. We also keep GAF and Owens Corning ridge vent profiles in our shop for mixed-brand or out-of-warranty roofs where OEM matching isn’t required.
Ready to Get This Fixed? Call (448) 218-0800
Your attic gets hot enough in Orlando in the summer without a failed ridge vent making it worse. We’ll get you a free estimate, itemized in writing, before any work starts. You’ll know what the part costs, what the labor costs, and exactly who’s coming to your house. If it’s not in writing, it’s not a promise, it’s just weather talk. Call (448) 218-0800 any time, day or night. A real person answers.
Written by Dylan Pace, Owner, Crestview Roofing Co Orlando at Crestview Roofing Co Orlando, serving Orlando and nearby areas.